Calculators / RC Low-Pass & High-Pass Filter Calculator

RC Low-Pass & High-Pass Filter Calculator

Calculate RC cutoff, gain, phase, and frequency-response plots. Reverse-design R or C for a target cutoff, then check the actual standard-value result.

Inputs

Try the prefilled example, or enter your own values.

Result

Calculate to see the result and worked steps. Changing an input clears the previous result.

How to use

  1. Choose low-pass (output across C) or high-pass (output across R). Analyze existing parts or find a component for a target cutoff.
  2. For reverse design, the selected E12/E24 part minimizes actual cutoff error within the supported range. All plots use that selected value.
  3. Enter a sample frequency for its gain and phase. The plots span 0.001fp–1000fp around the pole on a logarithmic frequency axis; the table lists physical frequencies.
  4. Enter source/load/ESR in Ω, using blank RL for no load. The time-domain link illustrates the equivalent pole rather than the complete loaded waveform.

Formula and assumptions

Ideal unloaded: fc = 1/(2πRC). Loaded LP: τ = C[(R+Rs)∥RL+ESR], H=(H0+j(f/fp)H∞)/(1+j(f/fp)). Loaded HP: τ=C[Rs+ESR+(R∥RL)], H=H∞j(f/fp)/(1+j(f/fp)). fp=1/(2πτ).

One resistor and capacitor, with optional source resistance, a resistive output load and constant capacitor ESR. Supported R: 0.1 Ω–10 MΩ; C: 1 pF–1 F. Reverse targets: 1e-12–1e12 Hz. Ignores inductive parasitics and component tolerances. The pole and relative −3 dB cutoff differ when ESR creates a shelf; a large shelf can prevent that cutoff.

Sources

Worked example

With an ideal source, unloaded output and zero ESR, at fc both first-order filters have gain 0.7071 (−3.0103 dB); phase is −45° for low-pass and +45° for high-pass. For 1 kHz with 100 nF, theoretical R is 1.592 kΩ; E24 1.6 kΩ gives about 994.7 Hz.

Common mistakes

An unloaded RC formula changes when a real source or load adds resistance. At exactly 0 Hz a high-pass output is zero, so its phase is undefined. The −3 dB point is not zero output.

Continue your circuit