Calculators / BJT Base Resistor Calculator

BJT Base Resistor Calculator

Select an E24 base resistor for a low-side NPN switch using forced beta and a driver-current limit.

Inputs

Try the prefilled example, or enter your own values.

Result

Calculate to see the result and worked steps. Changing an input clears the previous result.

How to use

  1. Enter on-state load current and a forced beta supported by the transistor’s saturation test data.
  2. Enter the driver’s guaranteed high voltage and available source current.
  3. Read the selected E24 resistor and check transistor/resistor dissipation at the intended duty cycle.

Formula and assumptions

IB,required = IC / βforced. RB = (Vdrive − VBE)/IB. Ptransistor ≈ D(VCE,satIC + VBEIB).

Low-side grounded-emitter NPN, constant on-state collector current, fixed VBE/VCE(sat), and a stiff logic-high voltage. E24 selection provides at least the requested base current without exceeding the entered driver limit. No switching-time or inductive-energy model.

Sources

Worked example

At 10 mA collector current, forced beta 10, 3.3 V drive and 0.8 V VBE, the theoretical base resistor is 2.5 kΩ. E24 2.4 kΩ gives 1.0417 mA base current.

Common mistakes

Small-signal hFE is not a guaranteed saturation ratio. Verify logic-level droop, GPIO limits, the transistor pinout and flyback protection for inductive loads.

Continue your circuit